output flow control is unsupported cisco switch

[QUARK TARO]

I have one 3850 and 9300 switches that need to be interconnected using LAN cable.

3850 supports 100Mbps, I have interconnected using LAN cable but the link does not come up. It gets into error -disabled.

On 3850 I see a lot of input errors on uplink port and 9300 I see flow-control is unsupported error.

How do I resolve this?

[Reza Sharifi]

Make sure the ports on both switches are configured with the same speed and duplex. If the 9300 port is a Gig port, ensure the 3850 is configured the same. If one side is 100Mbps, make sure the other side is the same. Most likely you are dealing with a speed mismatch on one of the switches.

HTH

[QUARK TARO]

I have tried auto for speed and duplex. 3850 switches does not accept hard coded  full duplex

[Reza Sharifi]

Are you using copper ports of fiber? Can you post the configs from both switches? "sh run interface g1/0/x"

and "show interface g1/0/x"

HTH

[MHM Cisco World]

ErrDisable and flow-control

Can I see 

Show interface 

Show interface error count 

MHM

[QUARK TARO]

I am attaching available output from both switches, port 24 and 45 are interconnected using LAN cable.

[MHM Cisco World]

I need to see also

Show interface error count 

MHM

[Reza Sharifi]

Try replacing the copper cable with a different one.