Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My Cisco Prime is measuring bandwidth ratio base on hard interface's bandwidth. For example, there is 10M current bandwidth on 1G(1000Mb) interface router, Prime show the ratio is 1%. But on this 1G interface, I plug the connection which 100M bandwid...
HI all,
I connected 2 Cisco Switch via 2 ports 1G-full duplex, I used straight cable, when I do "show interface status", then, port up but they are display only 100Mb speed. Does the straight cable is root cause of this problem ? should I change to c...
I configured my switch synchronize time from NTP server, I do "show clock" command and got everything seem ok, the switch got correct time(UTC:+7), but when I do "show logg" command, entry log display in incorrect time-zone. (UTC:0), which wrong here...
I am reading about cisco syslog, i don't really understand some parameters
- monitor logging
- console logging
- trap logging
Anyone can tell me what different of them are ? Thank so much!
I know there are 16 privilege levels of cisco router/switch manage account (from 0-15). Anyone tell me detail what difference of these level are ? or any document about this ? Thank all!
Thank Mark,
Summary :
- Trap logging is the log which will be send to syslog server.
- Console logging is log appear when we have console connection to device.
- Monitor logg is log appear when we have remote connection (telnet, SSH)
is that right?
