Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We're looking to replace an existing iWAN installation with DMVPN. The current setup utilize MPLS and INET in each location. We will be replacing MPLS links with second INET links, so each site (7 total) will have 2 Internet links, and 2 Rou...
We need to implement a dual firewall (ASA’s) solution to provide some connectivity between 2 separate Networks that are in the same physical location. Each firewall will have an interface connected to a switch. The switch will be configured with t...
I am looking for a SSL VPN Solution for our Company that would scale to 700+ users in the next few years. We are currently using the Avetail SSL VPN, and although it does a good job, the licenses are a bit expensive and we do have an opportunity to ...
I am working on a plan to upgrade the Network to accommodate for a newly installed VoIP (none-cisco) solution and for the potential growth. The existing setup has around 14 3560’s dual-home to the Core (pair of 4510’s).The plan is to upgrade the Cor...
Hi,I upgraded my CW Campus Manager from 5.0.5 to 5.0.6, and now when I try to access CW I get :Internal Server ErrorThe server encountered an internal error or misconfiguration and was unable to complete your request.Any idea how to fix this?Thanks i...
HSRP for sure, but do you think since I have 2 routers in each spoke that I should go with the Dual Cloud design? If so, would each spoke router have a single or two tunnels to each HUB routers? I would think each spoke router will need to connect ...
It seems a lot of the examples I see are based on a single router in the Spoke. In my case, each spoke will have 2 routers, router-1 will have ISP1, and router-2 will have ISP2. We don't want to load balance the traffic, active/standby is probably ...
Thank you! I am assuming I should go with Dual Hub, Single Cloud design? If so, that implies the following: 1. Each hub router will have its own subnet for the tunnel interfaces?2. Two ip nhrp nhs statements for each spoke router?3. Two nhrp net...
Thanks all! I guess I will just use static routing.One last question. How do you recommend connecting the firewalls in dual setup? Would a cross-over cable do the job or is it better to use the switch?Thanks
