Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm a bit disappointed by the In Touch, I configured a LAN port properly like every other and connected it to the same VLAN like the C20, after some IP / ARP issues which are now fixed, the touch starts and it shows "connecting..." but nothing...
Hello,I've got some troubles with the WLC 4402 for some days. I have a Lab with the Management VLAN 10 in the range of 192.168.1.128/27. The WLC Management interface has the 192.168.1.137 and the AP Manager has the .138, I have two VLANs with two SSI...
Hi,thanks for all the answers, but it still not working but honestly I think it is more a network issue right now, the port is flapping all the time. I will check it on Monday with another Switch and C20. Thanks again and have a good weekend.
Hi,yes the Telnet port was open at the codec but I found an option systemtools pairing, has this something to do with it? Honestly I'm quite new to the VC endpoints RegardsMartin
Hello Mubashshir,thanks for the quick response but still I can't see anything and the touch shows connecting... here is my output of the xstatus systemunit *s SystemUnit State System: Initialized *s SystemUnit State MaxNumberOfCalls: 2 *s SystemUnit ...
yes its normal, because he is on his layer 3 switchwith the local configured VLAN Interfaces so the vlan Interfaces for VLAN 20,30 etc is local connected.Can you see the eigrp routes on the other neighbours?have you configured to trunk all vlans to t...
