Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
access point Cisco_AIR-AP2802I (Cisco AP Software, ap3g3-k9w8 Version: 17.9.5.205) is configured to offer two flexconnect SSID , e.g. "Office" (VALN10) and "Factory" (VLAN20). On VLAN20 ACLs have been applied which is currently filtering DHCP traffi...
I am deploying access points in DNAC, for their proper positioning its needed to set Azimuth and Elevation per access point.I have not found documentation offering well described / illustrated process for correct Azimuth and Elevation setup, does it ...
as we know, per design new access point will get default tag policy, tag rf, tag site and will not provide wifi.I have N+1 WLCs and its quite inconvenient manually assign tags for new access points and then need not to forget configure such static as...
- Cisco switches (new generation e.g. 9300 or 9500-series) by default do not trust dscp and require explicit command for that by design ?!- is description exists with recommendation and best practices to deploy LAP QoS policy for microsoft teams ( p...
on AireOS it was convenient to see if access point works in "full power" mode or medium/low power , e.g. https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-6/configuration-guide/b_cg76/b_cg76_chapter_01111010.pdfBut I have not found similar ...
flexconnect profile name was wrongly written in config, which caused such problem.standard guide for flexconnect https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213945-understand-flexconnect-on-9800-wirel...
thanks for all suggestions:I've tested, its working. AP gets related tags and applies related new tags immediately if I change AP's name per my regex.Not convenient that WLC not offering a tool to test regexp, e.g.#sh ip bgp regexp ^abc% BGP not acti...
