Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There is no way to avoid this message "Next ACK ..." in situation where switch has no internet connection?Do I need to install Cisco Smart Software Manager satellite on premises in order to prevent doing ACK manually?C9200L, IOS-XE 17.14.1, DNA-E sub...
A client is connected to gigabit port on Catalyst 3750E (15.0(2)SE10a).Catalyst 3750 is uplinked via tengigabit port to Catalyst 6500 (WS-X6704-10GE, 15.1(2)SY15).Edge router is other vendor than Cisco and is configured to shape client's IP address d...
Cisco Prime Infrastructure version 3.7 supports SG350 switches.However an attempt to upgrade SG350 image fails:- Cisco Prime Infrastructure says Copy failed - Cause : Expected success prompt not received !!. - SG350 switch says: %TFTP-N-TIMERSEND: Se...
ASA 5550, software version 9.1(7)
Error message: Deny IP spoof from 192.168.54.114 to 192.168.10.1 (on interface MGMT).
interface GigabitEthernet0/1 nameif inside-srv security-level 100 ip address 192.168.10.1 255.255.255.0
interface GigabitEthernet...
I did some tests and it turned out that the problem might be tenGig interface at 6500.I configured exact QoS settings on 3750E which is not uplinked into 6500 and upload was 50 Mb as it should be.Also if 3750 interface is configured with CoS 3, uploa...
You didn't post your 10g uplink interface configYes, I did. Check 6500's QoS on port.TenGigabit interface on 3750 has only "mls qos trust cos" configured.
If you have shape already on the Edge, why are you applying QoS on the switch?Because of traffic prioritization.I´m assuming that it may be out of resource alreadyNo, it's not.
just check the username and passoword once againSG350 says %AAA-I-CONNECT: User CLI session for user prime over ssh , source 1.2.3.4 destination 4.5.6.7 ACCEPTED
