Hello,wrt eigrp configuration, i want to know - a) how a router on the LAN can be denied making neighbor relation b) how to filter routes To/From another neighbor router.(this is wrt to our multisite AVPN (at&T managed mpls service...
Hello,i recently deployed cat4507e switch along with 3 nos of WS-X4748-RJ45V+E - 48 port gigabit PoE modules. I am using polycom IP560 phones.I am facing issue of some switch ports (randomly) stops supplying power to phone at random time. So far th...
hi i have 2 x T1 terminating on border router cisco 3640 route. (configured using multilink interface). Our IP block is routed on this bundled T1 circuits by At&T. I want more internet bandwidth.1. Can i connect my DSL (on ethernet interface and usi...
Hii am looking for fair comparisions between cisco CSS 11500 series local area load balancer and other popular names such as F5-BigIP and Citrix - netscalar.My basic requirment is to loadbalance webservers (http or https) with cookie based persistanc...
Hi Edison,thanks for your reply.In my case, there are more than two routers on same vlan (one of that is MPLS router). We want to selectively make neighbor relation on eigrp and control selective route distribution - with routers on the same vlan. T...
update:after i reset the switch module last night, it is back to normal now. All ports are supplying power now.the IOS is IOS-XE 03.02.00.SG.regardsrakesh====
hi Leolaohoo,the supervisor is sup 7-E - WS-X45-SUP7-E.No luck with that show cable tdr.... command. There is no ouput when i run .. after waiting for more than 60 seconds.USCORE01#test cable tdr interface gigabitEthernet 2/14USCORE01#sh cable tdr ...