Dears,  Kindly note that I am working on an SD-WAN deployment and need to run two colors (Private MPLS and Public Internet). I tried to implement Option D (assigning NATed public IPs to the controllers). The Internet connection is up, but the MPLS co...

Hello All,  I need to know if we can configure Q-in-Q VLAN Tunnels on [ SD-WAN ] Cedges 4000 & 8000 or not Commands dot1q tunneling ethertype 0x9100  encapsulation dot1q 100 second-dot1q 200 pppoe enable group vpn1

Hello, I created the SD-WAN lab on the eve but I have an issue between the vedges and the vsmart. find the below screen  Vedge-2# show control connectionsPEER PEER CONTROLLER PEER PEER PEER SITE DOMAIN PEER PRIV PEER PUB GROUP TYPE PROT SYSTEM IP ID...

Dears, We have a Cisco SD-WAN router and the Riverbed in the branches, like the below design, and the traffic is dropped when running the IPS [ Intrusion Prevention System ] on the Cisco SD-WAN router.      

  Hello All,  We run the BGP over the IP Sec Tunnel, so we need to create the PAT to translate the incoming IPs from FW 1 to the loopback interface to communicate with the other subnet in the firewall 2 via the loopback interface. so i need to know h...