Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking for a feature/command on Nexus 9K device. The requirement is to drop mcast packets on trunk ports on a certain vlan but only on certain trunk ports. For example Port 1 and 2 is a trunk port each carrying vlan 100 and 200. I want to blo...
SDWAN Controller version 20.18.2Using Configuration group and Policy groupTried to attach NGFW policy to policy group and when deploying (C8235-G2) getting the below error"Device generic generation failure : Configuration generation failed with error...
SDWAN Controller version 20.18.2.1
WAN Edge -- C8235-G2
The customer has 3 transports (say MPLS, ISP1 and ISP2). I want to create a AAR policy such that if the SLA is met certain traiffic will go via MPLS and if not met then it will go via ISP1...
...
The Wan Edge router is C8375-E-G2 and i am trying to create a feature template (Configuration > Classic > Templates) and under the feature template while adding a template trying to select the device and i do not see this device... what should i choo...
Team,
I am trying to configure an interface via Manage > Fabric > connectivity > interface -- Edit configuration.. Configuring all required parameters including the Access VLAN... and deploying it.. All successful..
Now when i go to Manage > Segm...
I was searching and got the following configuration.. is this valid (could not find in the command ref for nx-os)mac access-list MACL_DROP_MCAST_V10010 deny any 0100.5e00.0000 0000.007f.ffff vlan 10020 deny any 3333.0000.0000 0000.ffff.ffff vlan 1003...
This is a IPTV network which we are flooding the mcast traffic... so we get input feed in one of the trunk links and we might be fwding it to say to other customers/SP on a different trunk link.. since it is L2 we want to block the reverse traffic if...
do we need to copy the utd image to the wan edge router? or the vmanage will push it during deployment?.... i understood that in 20.18.2 the utd image is pushed by vmanage to wanedge... someone can clarify this it would be helpful
I am not getting that error after using untrusted zone but now when deploying i am getting the below error.. the virtual image is uploaded... (even checked the utd recommended version...)[16-Apr-2026 14:04:12 UTC] Deploying device with Policy Group A...
I think the problem is i have created a zone for vpn0 and referenced it in the rules.... i understand that vpn0 should be untrusted zone (please correct me if i am wrong)... and cannot create a zone for vpn0... the requirement is to inspect the traff...
