Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community,I am trying to allow port 80 through a ASA 5506 firewall from my DMZ to a INTERNAL zone for a HTTP server. I am having a problem with the access list, and have encountered a strange problem. The ip address of my HTTP server is 1...
Hello Cisco Community,I'm new to networking. Where should my default gateway be on this topology for VLAN 10? I would like 192.168.1.1 to be the default gateway. The firewall is my edge device. I'm guessing it's on the L3 switch because I don't belie...
My college professor has asked me to design a network (on packet tracer) that uses a ASA firewall, as well as a IOS Router Firewall to protect the DMZ. As shown in the screenshot.I'm struggling to understand why we would need a combination of differe...
Hello,
I'm studying for the CCNA, and trying to figure my head around dynamic routing.
The task is to set up 3x autonomous system that uses the protocols ospf and bgp to set up dynamic routing and to share ip routes.
These are the steps i have...
I accidentally added a wrong VLAN onto my ASA 5505 Firewall. How do i remove / delete it? I have tried the command 'no int vlan 10', but it doesn't work? Thanks in advanced.
Finally, got it to work thank you. There seems to be a bug with packet tracer saving the global policy-map. It does not always register it on my computer, and then when i restart packet tracer it restores it to default. Even when using 'Write memory'...
Thank you for trying. Still cannot get it working on my computer. I have tried multiple times - starting with a new 5506 firewall. It works perfectly on the 5505 with the same config, but not on the 5506 firewall. I am on a arm computer, so might be ...
Hi Rob, am i right in saying that the default security-level rule will only work when there is no other access list bound to an interface? So if I was to extend the network and add additional access list rules, would that stop working? What access-li...
