Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several ap 1231g in my network wireless and i use notebooks ibm r40 with cisco mini pci wireless adapter.The operating system of notebooks is win xp sp2 in zero-configuration wpa/peap mode.when the 1231g worked with ios 12.3(2)JA2 all is ok, a...
I have 30 ap 1230 in my network with ios version 12.3(4). I use cisco client e not cisco client with leap and peap authentication and all work fine.I have upgrade one access point 1230 to ios 12.3(8) and all my clients are ko.they not receive any wir...
I have my access-points AIR-AP1231G-E-K9 with IOS 12.3(2)JA2 configured in wpa mode.I have a notebook xp SP2 with cisco AIR-CB21AG-E-K9 card.The PEAP authentication is managed by windows and works on a cisco ACS version 3.3.The problem is that if i e...
I have a cisco c2950 switch and i monitor interfaces counters to see errors . I tried to reset interface counters from the CLI interface with "clear counter interfaces" command , but in the CMS web page the counters never reset. My question is : wher...
I have a pix 506 for user remote access with pptp andcisco-vpn-client.The remote users are authenticated with a cisco acs 3.2When the remote user connect with cisco-vpn-client i see the caller-id in the radius accounting page on the acs , but when th...
Hi Frank,I have made the custom installation of the latest aironet client software , and i have installed only firmware e drivers for xp sp2.I have not installed the ACU e Monitor software.In my lab test i have a syslog for diagnostic messages from t...
thanks Frank,but i have already upgrade the firmware e driver of my cisco 350 mini-pci adapter (i use ibm r40 notebook for test) . I have installed the latest ios on access-point (12.3(8)JEA). the problem of the disconnect persist...
This is a part of "sh ver":AR10-SWC2950_C#sh verCisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA1, RELEASE SOFTWARE (fc1)Copyright (c) 1986-2004 by cisco Systems, Inc.
I not get error message.my remote access work fine.the problem is only thatin radius accounting page , the columns "calling-station-id" , "framed-ip-address" etc. are blankwhen i ise pptp.if i use the cisco vpn client all columns reporting the correc...
