Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to form a pim neighbor with routers on different subnets? I have two routers but in between are two taclanes. So the routers are on different subnets but if they do not form that pim relationship, I am assuming my multicast traffic wil...
Have new Cisco UCS c240 that I installed ESXi 6.0 on and have configured the esxi host management network. However when trying to text the management network my connection fails. I am unable to ping the gateway. Not sure where the problem lies, the d...
Hi,
I was attempting to upgrade the CIMC and BIOS firmware on my UCS C240 M4 server. When using the Cisco Host upgrade utility I selected the CIMC and BIOS and hit update. When the update was finished. I hit exit and my server immediately shut off. ...
Good Morning,
I am trying to find info on updating certificates on CUCM and CUC. Currently we are using self signed certificates however would like to use third party certificates from a external CA. This is DoD environment so request would need to ...
Running Cisco ISE on a VM and when I enable client authentication and tried to login using my smart card I revice a HTTPS 500 internal error and it stated to check the log. When looking at the log I get the following error:
124 ERROR [admin-http-poo...
so basically i have a router on one end which connects to a taclane that taclane in turn connects to another taclane at a different site which connects to a router. Both of those routers are on different subnets. So from my understanding tehy will no...
my upstream port is configured as an access port and there is no tagging configured. how do you disable the LOM ports on the CIMC I do not see an option for that.
