Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4500-X switch running IOS-XE cat4500e-universalk9.SPA.03.08.01.E.152-4.E1.bin
I have configured it for NetFlow to a Prime engine (version 3.1)
The Prime does not recognize the 4500-X as a valid NetFlow source.
How can I verify that NetFlow t...
I am attempting to set up AAA authentication to two Radius servers.
When I run a test aaa group command I succeed in authenticating. However when I attempt to login using SSH I cannot authenticate.
I am attaching the pertinent config statements belo...
We have a pair of 5520's running 8.2(5) in Active/Standby mode and we want to upgrade to version 8.4(7). Due to the number and complexity of the NAT statements we have elected to re-construct the NAT statements by hand.
With the Primary unit active ...
I am attempting to do a password recovery on a 3850 switch stack running 03.06.05E. When I bring up ROMMON I cannot enter the command SWITCH_DISABLE_PASSWORD=0 because it is read only.
I attempt to bring up express setup because whenever I reboot it...
This may seem like a simple question but it is one which I cannot find in any of the documentation.
I have a client with multiple IPSEC L2L VPNs head-ended on an ASA 5512.
According to the client some of these VPNs are split tunnel and some are full ...
I managed to get in. The steps that I took were:
Power cycle the switch and hold down the Mode button until it brings you into ROMMON.
Enter in the command switch: SWITCH_IGNORE_STARTUP_CFG=1
(This doesn't seem to work since it still continues to lo...
Hi Puneesh.
I've attached a file with the pertinent crypto information.
Here is the chronological sequence of events:
Four sites were involved: Oregon (the hub) and the UK, N. Calif., and S. Calif. (spokes). N. Calif. and S. Calif. are full tunnels ...
I am experiencing something of a similar problem, although this involves a client with multiple IPsec VPNs to remote sites.
When we implemented the second VPN using the 'any' clause in the crypto ACL we suddenly lost traffic to the first site, which ...
