Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, i have an issue with a link between a Cisco 7609 and a Cisco 7606.This link is managed by a service provider with their own routers.I want to check regularly if the connectivity between my 2 routers is correct (i don't want to check physical ...
Hi,I'm looking for a tool which can modify wifi encryption of my 500 x 7921G phones.I found the Bulk Deployment Utility but "All Users" have to reset their phones to factory default.Is there a way to do it myself ?Thx
Hi,I'm installing a WCS solution with 3 controllers 5508 and 70 access points. (AIR-LAP1041N-E-K9)Everything is working fine but i have 1 issue with WCS and RF.When i add some Access Points into the maps, some are working fine but others not.I've got...
Hi all,i have a problem to configure SPAN and RSPAN on the same switch.I have 2 switchs : Sw1 and Sw2I want to make mirror ip phones from both switch to the interface fa0/1 on Sw1.I created my RSPAN vlan (1000) on both switches.On Sw2:monitor session...
Hi all,i had to make a capacity planning script for my customer but I really don't find an issue.My main problem is that i'm using EEM v2.3 and I don't have all features.So, i want to catch the result of this command : "sh platform hardware capacity ...
I confirm ... i tried to configure rspan but it doesn't work
And for erspan, 3650 only support erspan as a source switch in the latest versions (denali and everest), the same for Nexus 9300.
I had to connect my sources and destination devices on the ...
Hi Mark, do you know if I rspan trafic can be carried through a 9300/9500 like that even if my rspan vlan is not declared as remote-span :
SourcePort --- 3650 SourceSwitch --- Nexus9300 --- 3650 DestinationSwitch --- DestinationPort
the IP route table object is empty like many other ospf object...thank you for the link, i didn't know about this tool !I didn't find any object on mpls ldp neighbor (because I use MPLS on my network), do you know if something like that exist ?
Hello Marvin & Vinod,Thanks for your response. Vinod, i don't believe my interface goes operationnally up/down if i have a cut, the network between my 2 routers is a MPLS. Marvin's solutions are probably the best except that i didn't find any object ...
