About Tonay.R

Tonay.R · 01-31-2025

I was using IOS XE and moved to NCS540L IOSXR. OS Version 7.7.21I used policy-map to achieve my PBR requirement for multiple default-route in IOS XE. In XE there is no such option to achive the PBR according to my needs. There I also found ABF (ACL B...

Tonay.R · 07-04-2024

I am facing an issue and confused about the output. Configured GRE tunnel in a VRF and Tunnel IS UP with no Ping loss in Tunnel interface IP. But when I add a route or some BW then it started huge p2p loss and tunnel gets up/down and ping loss again....

Tonay.R · 04-15-2022

I was trying to use route-map for some bgp neighbor what is configure in vrf. I have noticed the route-map is working only for OUT filter, but IN filter is not working. Ex: I have allowed the neighbor 10.40.40.2 to rcv specific IP inbound IN route ma...

Tonay.R · 07-06-2024

Yes tunnel destination is reahable via MGNT vrf RIBUsing static route to forward all to another router where INTERNET is connected. Using this route, tunnel destnation is reachable. And I have also verified that Tunnel p2p IP is in MGNT vrf as it sup...

Tonay.R · 07-03-2024

I am facing the same issue in ASR920 real environment. Did you dot any solution?

Tonay.R · 04-16-2022

Thank you very much for the information. It means a lot

Member Since	‎04-15-2022 11:10 PM
Date Last Visited	‎02-03-2025 12:04 AM
Posts	6

User Statistics

User Activity

PBR config in Cisco NCS540 IOS XR

Gre Tunnel on VRF BW issue, ASR920

Route-map IN is not working with bgp neighbor (VRF), OUT filter is ok

Re: Gre Tunnel on VRF BW issue, ASR920

Re: GRE Tunnel Bandwidth Issue

Re: Route-map IN is not working with bgp neighbor (VRF), OUT filter is