Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have a problem of dhcp conflict on my core switch cisco 4500 E.
I found in some other discussion that i can resolve this issue automatically by activating the dhcp resolution by executing the following command "ip dhcp conflict resolution [...
Hi guys,
i have a problem with my vlans configuration. yesterday, i added a new subinterface in my server firewall in order to put there a new server. this new vlan has the same configuration as other ones associeted to old subinterfaces. But a stran...
Dear all,
I have two redondant switch core cisco 4500 E series. Between the two switchs there is EtherChannels. The same DHCP pools are defined on both of them. On the vlan interfaces configuration on the second switch we have mentioned a standby mo...
Hello all,
My client has two cisco Aironet 1131 access points and he wants to buy a wifi controller in order to control access specially for guest users.
For this case, i suggested to buy the cisco 2500 series wifi controller (the model witch suppor...
Hello all, Recently, i have installed ASA-5512x. Internal users (LAN) are able to browse different web sites. However, when executing ping to any of these websites they get the "Request Timed out" response.I guess there is something wrong on the ASA...
Hi mark,
We dont have this problem. Our issue is that we have two core switch with HSRP and they act both as dhcp servers with same configuration of pools. Thus, when the first core switch isnot available, the second one will respond to dhcp clients...
Thank you Mark for the explanation.
Just a last point about when i will exclude the half of the pool on each, will i get all machines served an IP address or there will be a deficiency?
i guess it will not be but i'm not sure
Thank you very much
Hi pwwiddicombe,
Just i want to know and understand why "the standby config you have has nothing to do with DHCP at all"?
i haven't a deep knowledge about the HSRP
Thank you for your further help
Marwa
Hello,
Thank you all for your responses. I have also one other question: there is no problem to get a wifi controller for only two access points ? because the client will get first the controller for the two that exist and then he will get new ones
...
