Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We are getting a lot of FCS-Err in one FC- GIgabit trunking interface between Cisco Catalyst WS-C3560-48TS running IOS Version 12.2(25)SEE3 and DLINK 3120 Firmware 4.00.015.Our config in the cisco is the following:interface GigabitEtherne...
Hello,
I have a VPN between my on premise servers and MS azure and it is disconnected every one minute more or less.
I have attached a debug file generated into the ASDM.
192.168.213.0 is the Azure Network and 10.xx.x.x are the on premise networks.
...
Hello I´m trying to setup 802.1x on an old 3560 switch.The Switch is a:Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 52 WS-C3560-48TS 12.2(25)...
Hello, I trying to ping from one interface to other interfae , submask is 116.ASA# ping ipv6-test XXX:XXXX:1111:1:0:0:0:2Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to XXXX:XXXX:1111:1::2, timeout is 2 seconds:No route to host XXXX:X...
Hello,Finally I have solved the issue, is mandatory have the same networks in both extremes.Local networks in azure have to be exactly the same in the crypto map ACL of the ASA 8.3 deviceLike these lines :access-list azure-vpn-acl extended permit ip ...
I have a clue about how to do it.I use in the asa the fallowing command:snmp-server host DMZ 10.153.50.5 community *****snmp-server enable traps entity config-change fru-insert fru-removeAnd I setup a snmptrapd on a lin /etc/snmp/snmptrapd.conf# Exam...
I still have the same problem, but I don´t have the problem between machines, only between ASA interfaces, I think it is a "feature" or something like this, if it isn´t a feature I don´t understant it.Thanks
