Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We are working on TE within our MPLS environment and want to employ CBTS. I have configured this according to the "MPLS Traffic Engineering: Class-based Tunnel Selection" doc. The tunnels are up but do not seem to be recognizing the configure...
Here is the breakdown:We are running CallManager 4.3(2)We have multiple clusters connected to a gatekeeper using H225 Gatekeeper controlled trunks.Calls between clusters are working fine except for one group of phonesThese phones are remote site to t...
I am running CalManager 4.3(2) and we are having the following issue. Please see attached picture for basic layout.ConfigurationCCM B is connected to Old GK using a H225 trunkCCM A is connected to New GK using an H225 TrunkRemote zones are configure...
Here is my scenario:The customer would like the Front desk phone to ring for 20 secondsIf no answer between the hours of 0800 and 1700 the call should roll to a hunt group for all engineersIf no answer there it will forward to the answering serviceIf...
Hello All,I have Intercom configured on some phones in our lab system and it is working as advertised.What I am trying to do now is figure out how to setup a button on the phone that acts as a targeted or speed dial intercom button. This way all som...
I am still trying to gain access into the other Cluster A CUCM. I was thinking Codec negotiation also. I am set to use G.729 but blew it out to Swideband so it should negotiate any codec the other end is advertising but I still got a fast busy. I ...
Also, to take the gatekeepers out of the equation, I built an ICT between CCM A and CCM B. I am getting the same call behavior while routing over it as I was when routing through the gatekeeper.
Yes, SilenceI activated MOH and set to use G.729When you place the call from CCM B to CCM A you can put calls on hold and resume with no issue. MOH works When you call from CCM A to CCM B and you try to place a call on hold the call fails.
