Chris Russo

Thanks, I just had to wait like like 10 minutes for the GUI!

oh ok thanks I'll play with that.. Are you sure this isn't anything to do with how my class-maps are...

so mark it by applying a service policy to the LAN interface as it comes in with DSCP values? I have...

This is what is configured for: interface ATM0/0/0 no ip address no atm ilmi-keepalive bundle en ! d...

Ok I put the configs on the physical ATM interface and it took the command. The issue now is that it...

It is a 1841 running 12.4T(13r), put my configs on the physical ATM interface and not the subinterfa...

I am trying to prioritize traffic for my PS3 to take priority over the other devices on my LAN. When...

We resolved the problem. To make a long story short, the IPS was blocking traffic after we changed f...

I didn't know that you couldn't have two NAT statements without using a route-map. We also tried usi...

I wouldn't change your config, just add that extra NAT statement and use the same source list ACL fo...

Your config looks fine. We have multiple nat statements for each interface we NAT to. Here is ours:i...

A static APN is different than a static IP. The APN is just basically the gateway for the cellular n...

I don't see anything that stands out. Adding that command to the cell interface should not cause oth...