About salomidhogela

salomidhogela · 09-11-2024

Hi, I would like to simulate a the following scenario whereby I have two MPLS (Dual ISP) and have customers connecting to the primary link ISP 1, when one customer let's call it CUSTOMER A ISP1 link is down and I am still active on my primary ISP 1, ...

salomidhogela · 07-05-2023

Hi All,I have multiple customers connecting via ipsec tunnel on IKEv1 and I would like to upgrade one customer to IKEv2 without interrupting the rest. Is it possible to run both version on the same router? Do I use the same crypto map applied on the ...

salomidhogela · 01-31-2023

I have an issue where by the mac address table is not refreshing on cisco 9300 switches. Cisco IOS XE Software, Version 17.03.05Regards,Salom

salomidhogela · 10-29-2022

I am experiencing issues with a Cisco 9300mac address table not refreshing. Mac Address are getting stuck on the interfaces. I have configured port-security on the interfaces.

salomidhogela · 09-19-2022

Good Day,I am current having issue whereby the macsec is not working between 9500 cisco 17.x.x on Layer 2. I used the below configsmka policy (name)macsec-cipher-suite gcm-aes-256exikey chain (***) macseckey 1000cryptographic-algorithm aes-256-cmacke...

salomidhogela · 03-06-2024

Hi,Did you managed with this upgrade?Regards,Salom

salomidhogela · 07-05-2023

How do I apply it on the interface? I do not have an option for the above, additionally can I use the same transform set?!Router1(config-if)#crypto map salom ?redundancy enable redundancy<cr> <cr>Router1(config-if)#crypto map salom!

salomidhogela · 07-05-2023

Hi Rob,Can I use the same crypto map for both ikev1 and ikev2 and apply it on the interface?Regards,

salomidhogela · 02-02-2023

show mac address-table aging-timeGlobal Aging Time: 300Vlan Aging Time---- ----------interface GigabitEthernet1/0/12description *******switchport access vlan Xswitchport mode accesstxSalom

salomidhogela · 02-01-2023

The timeout is current set to 4hrs, and from my observation this mac stays on the interface for even a month. Will adjusting the timer really resolve the issue. GigabitEthernet1/0/12 is up, line protocol is up (connected)Hardware is Gigabit Ethernet,...

Member Since	‎06-23-2022 12:19 AM
Date Last Visited	‎10-08-2024 04:07 AM
Posts	50
Total Helpful Votes Received	22

User Statistics

User Activity

Dual MPLS with two different ISP sharing a single public IP

IKEv1 and IKEv2 on the same router concurrently

MAC Address Table not updating

Cisco 9300mac address table not refreshing

Macsec not working between 9500 L2 switches

Re: 9500 stackwise system upgrade not ISSU

Re: IKEv1 and IKEv2 on the same router concurrently

Re: IKEv1 and IKEv2 on same Router

Re: MAC Address Table not updating

Re: MAC Address Table not updating