dear all, we are planning to shift our WAN from costly leased lines to cheaper MPLS connectivity. i just would like to know what is the reliability of Voice on MPLS. Since MPLS traffic is any available route, how can we assure that certain level link...
dear engineers,we do have cluster mail server with a single virtual IP address. whenever there is a failover happens remote clients cannot connect to the current active node. the router dont know the mac address of the new active node , untill it ...
Dear all,i do have 3 2600 series, one 1750 and one 1650 routers for my lab experiments. all of them having WIC 2 T installed. other specifications are usual. one ethernet, one aux, console ports.how can i connect to all of them, using a single te...
dear engineers,i have two 2 mb lines connected to a single 2600 router and iam using CEF per packet to do load balancing. it works fine. but all what i get is 40 percent utilization on both links, when i do a huge data transfer. why it can't reach...
yes,i have the same scenario and i have applied CEF (Cisco Express Forwarding) per packet with equal AD. and the load balancing is working fine.Regardstaib
i had the same issue with 2600 series router. whenever you try to connect to colsole it got stuck. there are work arrounds :a) id router has Ethernet interface configured with IP address try to conect your computer through Ethernet and do telnet (d...
sorry the my diagram was not good, try to see this, Router 1------------------------------- Router 2--------------- -- Router 3 E0(10.20.1.1) ------------------------ E0(10.40.1.1)------------E0(10.50.1.1) S0(1.1.1.1) ----------...
ok i got it.sorry but can you give me all commands that i have to do on both routers. i dont have any previous experience on such configurations..thanks in advance.regardsMohamed
you have to provide detailed info. what kinda DCE equipment you use.. is it G703 or V.35..? how come you connect WAN DCE cable directly convert to ethernet port..?please specify..?mic
