Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I cannot ping from my Cisco 9300 switch to another subnet on our network but I can ping from a PC on that switch to another subnet on our network. Why can I not ping from within the switch? I have a couple of switches on other subnets that can ping o...
I am trying to configure access from DMZ at one location to the DMZ at another location. I have a ASA5508 at location 1 and at location 2 we have an ISR C2900 that has our BGP configuration and a ASA5516 where the DMZ is configured. The office traffi...
I am looking for guidance on updating the controller and APs. Currently running on version 17.3.4c. Would there be any point of updating to the current Gold Star version of 17.3.5a if everything is working fine? Not sure I would like to go all the wa...
The solution was to add our inside IP block to BGP to allow it to traverse the network. Not sure how it was working before but we did upgrade to IOS 17.3.5 on our Catalyst 9300s, must've been some kind of bug that broke it in the upgrade.
The switch is connected to an ASA on the inside interface that is doing our routing. On the switch we have ip route 0.0.0.0 0.0.0.0 "ip of the inside interface" of the ASA.
