Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello people of Cisco. I have a question. I've tried working this out for several god dang hours but I just can't figure it out. I don't know what the problem the assignment is hinting to, is... I've tried changing IP addresses, put on codes (if it a...
Hello, i'm looking for help with this assignment: file:///Users/darabhaqnazar/Downloads/en_ITN_SkillsAssessment-Student_Exam_00%20%20oeve_uden%20point%20(1).pdfI have configured all the ipv4 addresses to the pcs, vlan, and router. I'm at page 8 where...
Okay, so i'm on 92%, but the last 8 remaining procent says that my pc's ip addresses are wrong and my router serial interfaces too. I don't understand why. Here's the assignment: https://assignment.itslearning.com/Annotations/AnnotationApp.aspx?Annot...
Hello, I would like some help for this VLSM subnetting. Classless subnetting I still haven't gotten down yet, but classful is easy enough since you use the same sub mask.So it gives me an IP: 192.168.1.0/24and it gives me 2 hosts: Router 2: 30 hosts ...
Hello, I would like some help for this VLSM subnetting. Classless subnetting I still haven't gotten down yet, but classful is easy enough since you use the same sub mask.So it gives me an IP: 192.168.1.0/24and it gives me 2 hosts: Router 2: 30 hosts ...
looked like i had the wrong subnet masks for my interface serials but even with those corrected I still only have 80% done. I've written all the other ip's you've sent and changed the pc's accordingly. What else do I need? I've provided the codes in ...
