687
Views
0
Helpful
1
Replies
Pinging and Tracing to Test the Path
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-23-2023 05:54 AM
Hello people of Cisco. I have a question. I've tried working this out for several god dang hours but I just can't figure it out. I don't know what the problem the assignment is hinting to, is... I've tried changing IP addresses, put on codes (if it asks for one, it's "class") and I've tried and failed tracing routes. I hope one of you fellas or gals can help me, because i'm stuck on this badly. The percentage just wont go up for some reason. Hope somebody can help, thanks in advance!
Labels:
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-23-2023 08:32 AM
its just changing of IP in R2 and ipv6 change
Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB
Good luck
KB
