Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,kindly check the below config, which i did on cisco 2960S switch at user ingress interface. but the marking is not showing in show policy-map interface gig 1/0/10 interface and ACL is not showing any match. I also had a config reference from 2960S...
Hi,I have a UCS Server C200 M2 Rack Mount and planning to install Windows 2008 R2 server in it. To make it High Available, i m configuring RAID 1 in it. I can easily configure RAID from BIOS setup and after rebooting it shows me that the RAID 1 is fo...
Hi,I am using ftp server over internet, for this I am able to connect with ftp server successfully but unable to transfer data. I am unable to see the file's list on connected ftp server. I am using the router Cisco 1941 with 15.0 (1r) M12. There is ...
Dear Friend, There is no metter to believe, as i attached here the screen shots for your review, Well the SW RAID is selected and the steps are performed accordingly but the issue is there. We have multiple times checked it and we also upgrade and d...
Hi Neeraj,Thank you for your response, I will check your recommend action on device and will let you know about it. Further, I will aslo send you the configuration and sh translation output.Thanks !
Hi Bob,Thanks for your response,Its mean you suggest to install IDSM-2 in promiscuous mode with updated signatures? or you have some other design for IDSM-2 deployment?Kindly adviseThanks in advance!
Thank you for your response!!!We are planning to deploy IDSM-2 at client site. Customer is asking few things:1. If we install it in promiscuous mode then what will be the best utilization and design for this module, how to configure it2. If we in...
