Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been trying to integrate a Lync server with a Cisco CUCM using a Direct SIP trunk. The key word there is trying.I followed the Microsoft document for the integration of Lync with Cisco 8.5. See attached file.When I dial from the callmanager to...
We're trying to get a Cisco Softphone (IP Communicator v7.03) to work across an ASA using the Phone Proxy. The softphone usually registers correctly with the ASA Proxy and hence the callmanager, but when we go to make a call from the proxy phone to ...
I have a GSS 4490 but only want it to be authoratative for certain hosts. Sysadmins don't want to lose control of their DNS records.How do I point active directory to the GSS to look up the host?I need to keep the AD domain as authorative for the DN...
I'm trying to get the machines to authenticate aginst active directory using 802.1x. This works great when I use PEAP and CHAP authentication. Works like a dream, no problems at all. But I need to verify that the machine is a part of the domain, t...
No I didn't. I haven't had the time to go any further into this issue. I do hope that the next few weeks provide me ith a bit of time to delve a bit deeper into this problem.If/when I do sort this out, I will post the solution here.
Hunt,I'm still trying to get my Lync to CM trunk working. What did you do to make yours work? Did you have to put a translation pattern on the Lync trunk? If so, do you have a resource on how to configure the pattern?Thanks,Mitch
We used: cipc security-mode authenticated.As far as ports being opened up, we had to open the ports necessary for the secured portion of the setup to include tftp. We did it both ways, with secure skinny and secure SIP and of course the secure RTP.R...
The big part of our problem was in the softphone saying that it wasn't secured. We changed the security mode of the CIPC under the phone proxy configuration on the ASA. Then we reset the certificate under the CallManager config for the phone, makin...
You do have to have two entries in the ACS box. So here's how I did it, I named one entry switch1 and the other entry switch1-radius. On the switch1 I selected tacacs on the switch1-radius I selected RADIUS (CISCO IOS PIX).Restarted the service and...
