Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,I’ve noticed a change in how the Location field is displayed in the "show ap summary" command on the new IOS-XE 17.15.x compared to 17.12.5.Setup for comparison:Production: Catalyst 9800-40 running 17.12.5 (Works as expected).Lab/Test...
Hi,looking more info about this bugid:https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwk32111 if such a message appears, this means that WLC enforce limit for 50 access points or it is cosmetic bug?
Hi,looking info for issue. Running wlc 9800-Cl, software release 17.9.5, flexconnect deployment. Sometimes client going to RUN state, but traffic is not passing. After 3-4 min. client reassociate and traffic is passing.Via log could see that:1) clien...
Hi, looking for help with configuration per-profile COA in ISE:New connected "ip-phone" is profiled as IP-Phone, but CoA not worked?On the switch side, most likely everything is configured correctly, since if I send CoA from ISE > Live Sessions it wo...
Hello, looking help for this issue - after the switch reloads, all RADIUS servers are marked as dead for the duration of the dead time criterion (15 min.). IOS Version is 15.2(2)E10. Configuration of RADIUS server are similar to this:aaa group server...
Thanks for the heads-up on the CSCwr20303 bug, I had actually seen this bug before, and since many of these bugs are highly situational and situational in nature, we decided to test it out ourselves.For now, our test controller running on 17.15.5 wit...
Thanks for the feedback, you're right in principle. I do read the release notes before upgrading, but I usually filter through the critical sections like - What's New, Important Notes, Behavior Changes, Open Issues, and specific Resolved Bugs we care...
Introduction:It’s funny how things work. For years, I relied on the WLC’s ability to centrally push location strings to APs as a key management feature. But apparently, Cisco decided this was a bug all along (referencing CSCwp06711). After upgrading ...
This situation leaves me in deep thought regarding my migration strategy. We were planning to purchase and deploy the new C9176 (Wi-Fi 7) access points, which require these newer releases.However, seeing such a regression in a TAC Recommended version...
Mark, thanks for the feedback...I have already tested this on a 9800-CL (version 17.15.5) and compared it with a production 9800-40 (17.12.5). The results are consistent: the behavior has changed for the worse.While the Wireless Config Analyzer is a ...
