Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Since the method of Smart Licensing Using Policy was changed, I am not sure which license to smart license.For example, if it is the IP Base license of IOS-XE, it is implemented by default, so I can use the functions without registering for the smart...
Smart Licensing Using Policy の方式に変更になってから、どのライセンスをスマートライセンス化するのかよく理解出来ておりません。例えば、IOS-XEのIP Base ライセンスであれば、デフォルトで実装されているため、スマートライセンスに登録せずとも機能は利用できるのですが、以下のNX-OS及びIOS-XEの機種についてはスマートライセンスに登録をしないと一部機能が利用できないのでしょうか？■N9K(NX-OS) System version: 9.3(8)・LAN_E...
下記URLに従って、ISEのHardeningをしているのですが、下記の要件を満たすための設定が見つからず困っています。https://community.cisco.com/t5/security-knowledge-base/ise-security-best-practices-hardening/ta-p/3640651<要件>"Configure ACLs that require ISE PSN access to specific ports (8443, 8905, etc, v...
I am following the URL below for ISE Hardening, but I am having trouble finding the settings to meet the following requirements.https://community.cisco.com/t5/security-knowledge-base/ise-security-best-practices-hardening/ta-p/3640651<Requirement>"Con...
Any information would be appreciated.
I just performed a ping on interface Loopback0, which is the interface where the IP address is assigned,I noticed that the Packet counter value did not go up.※When I ping myself, the result is the same.
#show r...
Hi @balaji.bandi I sincerely apologize for my late reply.Thank you for your answer.My way of asking the question was bad, so please let me change the question a little.I would like to check if the following devices and licenses are installed by defau...
Dear @balaji.bandi Thank you for you answer.I appreciate that you kindly answered my difficult question.I understand the procedure, but for example, if you have an IP-based license, it is enabled by default, so you don't need to register for a smart...
Hi @ammahend Sorry for the lack of clarity.Company policy requires the following requirements to be met by ISE, but I am being asked if the FW settings alone are sufficient security measures.https://community.cisco.com/t5/security-knowledge-base/ise-...
