Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dont know why netscout is not showing the actual bandwidth and top talkers. here is the config----------ip route-cache flowip flow-export source loopback0ip flow-export version 5ip flow-export destination X.X.X.X ip flow-cache timeout active 1------...
How do I translate the Destination IP address on PIX?For eg: I initiate a ftp session from one of the host from the inside interface to a destination IP address through a tunnel. I need to translate the destination address .
Is it possible to create a site -to-site tunnel between a 6513 switch and a PIX ?How can i achive this?Is it a good idea to create tunnel between a COre switch and another site?
How can i monitor the load on the switch..?______________cut_______sh catalyst6000 traffic-metertraffic meter = 0% peak = 5% at 08:24:37 CST Fri Sep 24 2004___________cut_________the above command shows 2004 sept data..-Biju
check the linkswww.cisco.com/application/pdf/en/us/ guest/products/ps5318/c1244/cdccont_0900aecd80221fe4.pdf http://www.cisco.com/en/US/products/ps5854/prod_configuration_guide09186a00802c3270.html
If you are not very familier to CLI, I would recommend to use the Cisco Express SDM WIzard to configure it Cisco 870 Series Integrated Services Routers for Small Officeshttp://www.cisco.com/en/US/products/hw/routers/ps380/products_data_sheet0900aecd8...
