Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using a ISR4451 as a CME with 8841 and 8851 phones. I performed the following on the phone:Settings (gear) button ➤ Admins Settings ➤ Reset Settings ➤ All SettingsI performed the above to wipe the CUCM settings so that I could configure the phon...
I need a 5520-WLC boot drive. I've been exchanging emails with a "Technical Consulting Engineer Wireless." She is telling me that I need to ship the 5520 to them because the SSD are part of the CIMC.I don't want to second guess, but that seems like...
Hi,As the title indicates. I have a 2960X switch that has two SFP+ interfaces. From everything I've read the SFP-10G-SR module should work in these 10 gig SFP+ interface.However, I get zero activity when I try to use these SFP-10G-SR module. Here ...
I have a few 1552E that are either VID 4 or 5. From what I've read VID 4 was the first version that came with 128MB. I'm running a WLC5508 with 8.5.182 and the AP supplemental bundle AIR-CT5500-AP_BUNDLE-K9-8-5-182-0.aes is installed. So I don't u...
I did that several times and still was unable to use "Cisco" "cisco" or any of the other on-line suggested default passwords to access the admin settings.Thanks again.
OK, then it is what it is - entire unit it is. I've never done this before and found the process counterintuitive from a business perspective. Anyway, I'm waiting for a response from the wireless engineer regarding starting the RMA process (who pays ...
