Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up two WLANs using four 9115AX AP's. I have a Staff WLAN which is accessed via a PSK, on the second WLAN I want to restrict access to the LAN and other clients on the LAN and just gives access to outbound traffic, so people on this WLAN ca...
I have purchased several C9115AXI-E, connected first one to the network and expect to see the AP Provisioning SSID. I cannot see the SSID on any devices. Looking on DHCP server I can see the AP has been assigned a lease and can ping this IP address. ...
Peer to peer as far as I understand works per VLAN as well; even though you configure it on the WLAN both Guest WLAN and The main WLAN which we want to isolate it from are on the same VLAN. We are provided 2 VLANs from a separate organisation we are ...
Is there a specific reason why the ACL shouldn't be done on the controller? I wasn't expecting this to be so complicated when on previous AP's it was a tick in a box.
I have been following the instructions to convert from ap to EWC but I cannot successfully send the image to the access point over TFTP:ap-type ewc-ap tftp://192.168.1.25/ap1g7 tftp://192.168.1.25/C9800-AP-iosxe-wlc.bin Getting Error [28]