Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,I have a simple HSRP connection with 2 routers , 2 switches for redundancy.Both the routers are used for load balancing instead of just one being Active HSRP and the other Standby.For ROUTE1 , Router1 acts as Active and Router 2 StandbyFor ROUTE2...
Hi ,2 questions :1.Is HSRP supported on an 1800 series router , if so which one???Has anyone practically tested it???Does it work fine????2. On a 2800 which card should I go for if I need a Channelised E1 connection???Can I have it on a 2811 ??? If s...
Does anyone know why this is happening and what this error means????our routers reboot every now n then and this is the error I see :System returned to ROM by bus error at PC 0x6095E6A4, address 0xB0D0AFDSystem returned to ROM by bus error at PC 0x62...
Hi ,Is there a tool to monitor the type of traffic passing in and out of the routers ( broadcast/multicast traffic)???Any suggestions????Thanks,Pallavi
Can anyone explain , what this interface output actually means????What does output drops indicate?????Input queue: 0/200/13108178/666 (size/max/drops/flushes); Total output drops: ...
Thanks for ur reply.I think I found the problem.Here is the link which would explain what might be going wrong with our routers :http://www.cisco.com/en/US/products/products_security_advisory09186a00807cb157.shtmlPlease do go through the document and...
Thanks for ur replies.Has anyone experienced the same problem before , if so cud I know what measures were taken to prevent/reduce this.Else I'll have to implement the queuing techinques.Many Thanks
