Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.
We have had about 37 Cisco IXM-LPWA-800-16-K9 operational for some 2 years now. They have been installed at different locations and powered by Cisco PoE switches. We are running LRR with Actility software. Intermittently, any LoraWAN GW may l...
We have some 600+ switches around the network and a huge amount of VLAN definitions that are not conform. Neither does every VLAN exist everywhere. VTP are not implemented due to various support on the switches. To make things even worse, there are s...
Hi all.
I'm having a Cisco Prime Intrastructure v3.10.1 installation and a WLC 5520 with v8.10.151 running on it. The AP count reported by the WLC GUI says an AP count of 606. Prime says 615, even after manual resync. I have tried to change an APs se...
Hi All.I have a C1111-8PLTEEA running Version 16.10.1b. It doesn't seem to have any info on the LTE modem. When I issue 'show cellular 0/2/0 hardware' i get this output:Modem Firmware Version =
Device Model ID =
Package Identifier ID =
International ...
Dear all.
I have an unmanaged switch, and I am trying to replace it with this managed Cisco switch:
Model: IE-4000-8T4G-E SW ver: 15.2(2)EA2 SW image: IE4000-UNIVERSALK9-M
When connect the three hosts that I have to the Cisco switch, communication st...
This helped me too. When I tried the command 'copy tftp: flash:' the first time, it started off well and stopped half way in the transfer. On the following tries it timed out over and over again. Applying the command 'ip tftp blocksize 512' allowed t...
It says:Router#pwd
bootflash:
Router#Does that matter? The command I issued was:Router#microcode reload cellular 0 2 modem-provision flash:/test3'test3' is a directory containing the firmware. It didn't accept the command when I tried with firmware f...
This thread led me to the solution:https://supportforums.cisco.com/discussion/11458276/siemens-profinet-and-cat2960s
"I found a document where si explained that "probably" siemens host are using packet with 802.1p header and vlan 0."
I fooled around ...
