About robertbrown877

robertbrown877 · 10-30-2007

Hi,I have been asked to look at a colleague's problem and I haven't touched multilink in a while, so when I looked at the initial output form various 'show' commands I think there still might be an issue. He has indicated that everything is working ...

robertbrown877 · 08-30-2007

hello,we have a 4500 switch with 2 vlans for voice and data, however through DEV team wanting more and more VM's there is a need to break up into different segments. we will all still need to have access to the core servers (exchange, file, AD, etc)...

robertbrown877 · 07-18-2007

Has anyone been able to configure OCS (Beta) where it's using CME (4.1)as it's IP Gateway? I know that mediation server would be needed to convert RTAudio to G.711, however i am looking for any successful installtions or indeed information gathered ...

robertbrown877 · 04-18-2007

I would appreciate some help in suitable method of translating a published number for a group XXXXXXX9640 and would like this translated to a ephone-hunt group pilot number (i.e. 5002), can anyone suggest the best method?

robertbrown877 · 04-16-2007

i have installed CME4.1 and have noted that incoming calls are being recieved (i.e. showing on screen) with the leading zero, this is based in UK. an additional problem relating to this is the redial option isn't working due to the missing 0, plus ho...

robertbrown877 · 11-01-2007

Hi Kevin,Once i checked this it was confirmed that 0/2/0 was actually down and this was due to an fault on the circuit. once this was corrected both were shown as 'active' from the 'sh ppp multi' and from the 'sh run' that both 0/2/0 and 0/2/1 are n...

robertbrown877 · 10-30-2007

Thats what i thought as well, however i will wait till close of play and then do the debugging of both serial interfaces, bouncing each one to confirm. I wasn't sure if there was some other config changes as the last time i had done this was with tw...

robertbrown877 · 10-16-2007

Thanks Tore,This is an excellent document, which covers all of the points I was interested in.Thanks again.Robert

robertbrown877 · 04-17-2007

Dave,Would it be possible to scan over the excerpt from my run-conf to give pointers, as all the dial peer information i've seen has been very USA orientated. So any tips or critisism would be greatly appreciated.

robertbrown877 · 04-17-2007

Dave,I know that this is a complete pain, but is there anyway to maintain both the 96XX extension numbers and also the (9) for outside lines as both these have been in place for a very long time?RegardsRob

Member Since	‎07-27-2005 03:10 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	19

User Statistics

User Activity

Troubleshooting Multilink Group (Serial)

4500 switch with current voice & data VLAN

Microsoft OCS 2007 and Cisco CME??

Translation pattern to convert number to pilot number

2 issues regarding (missing) digits on CME 4.1

Re: Troubleshooting Multilink Group (Serial)

Re: Troubleshooting Multilink Group (Serial)

Re: Microsoft OCS 2007 and Cisco CME??

Re: 2 issues regarding (missing) digits on CME 4.1

Re: 2 issues regarding (missing) digits on CME 4.1