Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a wireless network with an 1131AG in one building and a 2106 controller in my hub. The 1131 AP registers with the 2106 and I am using ACS as a RADIUS server for authentication, again no issues. My end clients are Dell laptops running the int...
I have a site that has two frame-relay DS1's built as point-point circuits. Both provide Internet access. I want to use PBR to send some user traffic over one T1 and some traffic over the other. I believe I've built the PBR correctly but it doesn'...
I have built an IOS Enhanced Conference Bridge using a Cisco 2811 router with IOS version 12.4(7b) Advanced IP services. The conference bridge works correctly, however when I try to add it to TACACS+ it won't authenticate. It then proceeds to lock ...
We are running port-security on a 3750-48PS-S switch running C3750-ipbasek9-mz.122-25.SEE IOS and we are experiencing a strange problem. We have a data vlan and a voice vlan configured on each port, we then run port-security sticky on each port with...
Our servers are reaching end of life so we decided to upgrade. However, we only purchased the servers, thinking that we could use the 4.1 software that we already have. I just received the new MCS 7835 H2 servers and our software is telling me that...
I have built an interface of the 2106 for VLAN5 and the interfaces for the 2106 and the bridges are built as trunks and all vlans are allowed. If I plug in a laptop on the 3560 in the new building, and the port is assigned to VLAN5, I get an address...
Ok, but if I dont have any static routes configured I am unable to route. I could ping the next-hop IP. With the static routes configured the route-map (set ip next-hop address) is sending my user traffic out the correct interfaces. No matter what...
Ok, I've got it working. I changed my ACL's to extended ACL's (no change), set the route-map to set ip next-hop (no change) and then I put a default static route pointing to each of my T1's. The route-map would then send the packets out the correct...
I changed the "set default interface" statement to a "set ip next-hop" statement still no change. I see the route-map matching packets, but am unable to route. As soon as I put in a static route pointing to either serial link routing starts working...
