Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,I am using different Cisco C9200L network switch (for example C9200L-24P-4X) and they are running 17.09.04a firmware.Corporate Cisco switches are monitored, using SNMP v2 community, by a third party montoring system.I did not apply any kin...
Hello,Does anyone knows OID to fetch VLAN data from a Cisco MDS 9000 Series?For example I know the following OID to fetch data from Cisco Catalyst switch (these OID don't work with NX-OS):VLANIndex - .1.3.6.1.4.1.9.9.68.1.2.2.1.2VLANName - .1.3.6.1.4...
Dear all,I am running a Cisco MDS 9148S. This device is running firmware is version 6.2(9).I looked for about SNMP Get-Bulk settings, however I did not found any information about it.Is this function enabled on SNMP agent running on Cisco MDS 9000? C...
Hi all,I have two Cisco AP AIR-CAP2602I-E-K9 and a Cisco WLC 2500.WLC is running firmware version 8.5.171.0In this moment AP and WLC are in the same VLAN.I get this error messages from Access Point CLI (I connected it to my laptop using serial cable)...
Hi all,I have a Cisco Catalyst 2960S-48LPS-LThis Cisco switch is running 12.2(55)SE5 firmware at the moment, but I would upgrade it to the latest software release (IOS 15.2.2E9).This switch is used in production, so I cannot reset it and perform upgr...
Hello@Mark Elsenthanks for your hint!@balaji.bandi NMS is Network Management System (Zabbix, Nagios, OpManager...).I used our network monitoring software to perform SNMPWALK (this software include a built-in snmpwalk tool).I used "snmpwalk" package i...
Hello,I am deeply agree with you for protecting snmp access to valid snmp managers throught ACL.>> the device will handle it kind of defaultI did not found a way to manage SNMP Get-Bulk on this Cisco MDS switch. Thanks a lotFederico
