Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to use capability transit to do some TE in the following topology:On R5 gi0/1 and R4 gi 0/1 is only in area 0. The interface gi 0/0 on R7 is administratevly down. Traffic from area 0 to the loopback of R7 from R5 goes: R6 - R4 - R7....
Hello,Just wanted to mention that in CISCO IOSvL3 packets originated by the outside nat interface are natted too if they match the source ACL although the command used is: ip nat inside source list ACL_SOURCE_NAT pool NAT_POOL. To mitigate this make ...
Hello,I am trying to get my IPv4 only Windows 10 PC to connect to an IPv6 network using ISATAP. The IPv6 network is hosted in GNS3 and the PC is connected to it using the cloud node:GNS3 TopologyIn this topology, R3 plays the role of the ISATAP serve...
1. The cluster ID is automatically asigned by the RR when it reflects a route and it is it's own bgp router-id. This is a loop prevention mechanism that assures that the 2nd RR doesn't reflect back to the first RR because it sees it in the cluster ID...
