Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm creating a new stack, i set up the first switch with all my vlans and IP routing, updated the SW to 15.2(3) web manager. I added the new switch, it fails to auto update, i run the command archive copy-sw.... as indicated in the console logs, and ...
Not sure if this is the right forum, but I'll post here and take any redirections I have a customer that has 2800 series router that used to be the hub for two remote branches and the NAT for the internet. They upgraded the service a few months back...
Hi,Wondering if on the ASA (8.4) its possible to do something like what DNS rewrite does, but with IP requests. Scenario. Mobile phone accesses a web app inside our network fine over cellular. Once it comes inside on to wifi it still has the publi...
Once upon a time this was working fine. Nothing has changed and I am the only admin, and now my SSL vpn just reloads the login pagewhen I login and registers a clientless VPN session instead of going to load anyconnect (the only enabled connection o...
I just installed an 5505 with a base licence. They had a spam appliance configured years ago with an IP from the same block they have, so its accessible externally. Right now to get this to work, i have to have a switch that the cable modem, ASA, a...
Yes the auto upgrade is on and it tries, then it fails with no specific reason reason really and in the failure logs it suggests the fix is to run the command i did as mentioned. The master switch accepts the command and then nothing happens. I lef...
Solved!I did a bit more investigating and why this didn't affect microsoft's site is still a mystery but I noticed transfer's over RDP were fine so I looked up the http inspect and noted several people reporting a bug with it so I saved the config a...
Hi Peter,I have permited the packet too big, and removed the tcp adjust comnmands. I have also enabled the ip-route cache as you mentioned and no change. I tried removing the ip inspect Ethernet_0 in from that interface and I think i lost web acces...
The ASA has its own VLAN connected to our switch that handles all the VLAN routing internally. Default route goes back out to the ASAWe do have a static NAT set up, and you are correct about thwe behaviour of the mobile device when it changes to WiF...
