Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe have 2 8300 series routers at a given location.1. Router 1 -- ABC2. Router 2 -- XYZWhen I ssh to router "ABC" using hostname it displays the prompt as -- "XYZ" >When I check the running config in this scenario, the hostname mentioned shows "XYZ...
Hi AllCUCM version 14.x. We have a 8861 phone deployed at one of the locations. The phone is used by the Command center team. They have a common user id and password which they use to login to the phones.On this new phone that is deployed , when the...
We have a site with 2 CUBEs. I would like to confirm the configuration for enabling HA between the 2 CUBEs.We have done the following configuration on both the CUBEs and applied the redundancy group on the correct interfaces.########################...
I am trying to modify/change parameters in the SIP message. Was able to successfully modify the Originator "o" field and VIA field in the SIP messages using the below commands on the CUBE. The change i wanted to do was to replace the IP address in th...
We have CUCM 12.5 and it is a 4 node cluster.We are trying to create a Calling Party Transformation Pattern as 3xxxxx, with the Calling Party Transformation Mask as the Main office number like +44 123 4567, so that when the users dial out external...
I dont see any ""username xxx password xxx"" config...There is password info mentioned under "line vty" config as followsline vty 0 4access-class vty_access_in in vrf-alsopassword 7 083A5F173615543A333317172B6120transport preferred nonetransport inpu...
I understand the output. My question was, at present i have NOT configured the "redundancy-group" under voice service voip for both the CUBEs.Does that mean that even though the output shows that the CUBE is in STandBy mode, the actual HA functional...
