Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've recently implemented ACLs to block network ranges from telneting to ur routers and switches from unauthorised IP address ranges which is working well. We would like to log attempts from blocked ranges, preferably to our NMS via an SNMP trap. Is...
Dear Reader,I have a L3 3550 (12.1) running OSPF, we are planning an enterprise wide IP migration. I need to route my traffic now based on source address, Legacy and new address space.I have a route map functioning using the ?set ip next-hop? command...
AP Model: AIR-AP1220B-E-K9We recently tried to upgrade this from VXWorks 12.03T to IOS, but something went wrong. We now get the following prompt only:c -- Copy filef -- File dirl -- downLoad file into DRAMu -- Upload filep -- xfer Protocoln -- coNso...
Our company are running OSPF over Cisco routers with 4 areas - 0, 2, 3 and 4.0 is the core area linking the others together.For end sites we don't put OSPF on as there's only 1 possible route out so we just add a default route and redistribute the si...
We are running 6509 WS-C6509-E Software, Version NmpSW: 8.4(5)The continuously occurring error that is displayed is as follows2006 Mar 30 16:17:46 GMT +00:00 %SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed2006 Mar 30 16:17:46 GMT +00:00 %SYS-5-RED...
OK thats great, thanks for your help!What about if I wanted to connect to hosts in the DMZ range though from the inside? As this is more secure to less secure won't this get NATed? If it is would I still have to setup a static translation for everyth...
Thank you all for your help, it's now working properly with the following commands:router ospf 1 redistribute static metric 64 metric-type 1 subnets route-map TESTaccess-list 1 permit 7.0.0.0 0.255.255.255route-map TEST permit 10 match ip address 1St...
