Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does any 2500 Series router with any specific IOS support inter-VLAN routing (Router on a Stick?) I have a 2513 running 12.2(29a) which I am trying to create sub-interfaces for trunking and it will not recognize the "encapsulation isl vlan-id" comman...
I am upgrading a half dozen 3640's to 128MB RAM. From my searching, it appears the 3640 requires 60ns, Parity or NON-parity, 72pin EDO memory. Looking at Cisco web-site not clear on this.I have installed some IBM 72pin, 70ns, Gold-lead, Parity memory...
When I dir flash: on a 3640 Router I see a file named y in memory. Why is this?It is on a few 3640's I am using in a test lab. I have been upgrading memory, and before the upgrade I try to copy file y to my TFTP Server for backup. On one 3640 I could...
Equip: 3600 (core_ro) to 2600 (wg_ro_a). Serial connection HDLC, core_ro se1/0, 10.140.1.1 255.255.255.0 to wg_ro_a se0/0, 10.140.1.2 255.255.255.0. All defaults. Turn on RIPv1 and get following, expected result.wg_ro_a: 10.0.0.0/24 is subnetted,...
When I power-on a 3640 Router with no adapters installed, all I see in Hyperterminal is a repeating "C" across the screen. What does this mean? I pulled this router from a storage room to see if it is working. It has two RAM and to FLASH SIMMs insta...
Would a 2509 or 2511 still be more than sufficient to provide Terminal Server access to a small test lab remotely? I'm building a small test lab at home and would like to be able to access it from remote locations. Budget is definitely a limiting fac...
Good thing these are borrowed then! Appreciate the information. I'll be working on my CCNP through next year and will need to build a small lab. Would it be worthwhile to have 2611 or 2621 (2 x FaEthernet) even if not an XM model, for things like hav...
Well, let me first say in my defense, I just started wearing reading glasses! Secondly, I did lean around the side of the rack case and reach over to connect my Console cable, without my glasses on, AND plugged right into the AUX Port!!! Duh! So much...
Correct me if I'm wrong, but if I'm experiencing the exact same problem, and I think I am, then when we type "enable" to go into Priviledged EXEC mode, we get message "% No password set." It appears there is NO Enable mode password to type in! I am d...
