Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Let's say we have an NBMA network (e.g. Frame Relay) and we configure NBMA mode on it.I found in CBT Nuggets that there must be full-mesh connectivity in an NBMA mode in order to have IP communication between all routers.However, Cisco Student ...
hi,i have one ACL applied on a router interfacewill a traffic in the opposite direction and matching the statements be allowed to pass?what if it does not match them?example:router(config)#access-list 111 deny tcp any any eq 23router(config)#access-l...
hi,i configured a FR multipoint subinterface to participate in RIP process. however i learned that, in this situation, split horizon rules prevent routing updates from being sent and received correctly. what should i do?
if the ospf interface priorities tie, you then consider the routers' IDs. as i mentioned above, when the router ID is the criterion to choose a DR, you can to distinguish two cases: 1. if you did not configure any loopback address on the router, then...
first, there is no "dynamic" inverse ARP. inverse ARP is a dynamic method to map layer 3 addresses with frame relay DLCIs.with frame relay networks, inverse ARP is enabled by default on multipoint connections( and if you like on all F-R interfaces fo...
