Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I was doing EBGP and IBGP configuration, i have done all the configuartions and routes to the destination is visible from
the routing table, but i am not able to ping it even if I source from my loobpack interface.
From the EBGP to IBGP the the b...
Hello,
I am bit confused with the prefix-list match statements, i want to get the match for this subnet 172.16.0.0/29 and correct if I did it wrongly
here is the line
ip prefix-list test1 seq 5 permit 172.16.0.0/16 ge 20 le 30 OR
ip prefix-list te...
Hi, I have two cisco 2960 switches in my lab, VLAN 20 is configured SW1-SW2 --- port 24 trunk SW1 port 13 is DHCP Server portSW1 port 1 CLIENT 1 is connectedSW1 DHCP SNOOPING CONFIGURATION,ip dhcp snooping ip dhcp snooping vlan 20interface fa 0/13...
Hi, I have established site to site vpn tunnel between ASA 5505 and Fortigate Firewall, the tunnel is up and also traffic from the ASA LANto the Fortigate LAN is perfectly working(ICMP,Telnet), but the traffic from Fortigate LAN to the ASA LAN is com...
Hello, I would like to know if i missing some configuration for OSPF/EIGRP route filtering using distribute-list, Left-router-center router running OSPF 1Right-router-Center router running EIGRP 1Problem:I am able to ping from Left-Router to Right ...
Hello p.dath,
Sorry,Earlier i was trying to ping from R1 but i was suppose to start the ping from R2
destintination have a route back to R1
B 4.4.4.0 [200/0] via 3.3.3.3(This next hop is R3), 10:06:23
Traceroute is getting stuck in OSPF Neigh...
Rizwan,Thanks for the clarification , but what I mean is that ,My local Webserver 192.168.45.5 will remain the same, but Our partner Encryption domains will be different i.e Partner Location 1Encryption domain 72.x.x.1Partner Location 2Encryption do...
Hello Rizwan,Can i use another Static nat policy pointing to same target server like local-private-ip----> Remote-encryption domain ----- interface outside ---- public natted ip addressscan i use the same static nat policy rule local-private-ip----> ...
Hi Hitesh,Thanks for the valuable tips, the phase 1 interface for the fortigate is enabled, and there is no routes that looks to be overridden. Attached is the Diag vpn tunnel list and Get router info routing-table all
