Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a MX80 shown under License Information but cannot see it listed on the equipment column.How can I please find out the configuration details on MX80?
I am from CCS background and am trying to understand how the VIPs could be configured on an ACE module (using class maps).I am looking for specific information for the following :1. Will each VIP have a corresponding Service-policy on the VLAN Interf...
When I tried to view the sys.log or sys.log.prev it display the inforamtion on the log file but terminates it with a truncated message.(--Truncated---).How can I view the entire file ?Could it be possible to rename sys.log.prev file so that the over...
The MAC addresses used for each virtual IP address on each VLAN is different (the last two digits refer to the VLAN ID.)Is there any command to to view the MAC addresses allocated for each VLAN on Master and backup boxes?
Therer are no Distribute-lists. See below 10.0.31.230. The Netowrk and areas are properly defined on the configuration.Any idea Please?? Thanks============asydr01#sh ip ospf data adv 10.0.31.230 OSPF Router with ID (10.99.0.1) (Process ID 10) ...
All seems normal except for you have taken two services out of action/service.Please try the following :1. Configure one port on the switch to which the servers are connected as a monitor port and monitor VLAN 103 and connect PC/Laptop with sniffer/w...
please post the output for the following commandsshow rule MOSS MOSSshow rule SSRS REPORTSERVER.show keepalive AUTO_MOSSWeb01/2/3show keepalive AUTO_SSRSWeb01/2/3You are using the same IP address for two service names with no distinct port numbers f...