I have a setup with 2 871s (spokes) and one 2851 (hub).Tunnel between 871s works but shows no crypto isakmp peer. Show crypto sessions details shows UP_NO_IKE. I think this is rather strange.One of the 871s has established tunnel to 2851. Otherone (s...
I need urgent information about the cause of the following errormessage 000094: Oct 3 16:56:34.520 buc: ISDN BR0 **ERROR**: process_bri_call: Outgoing call id 0x8004 blocked 000095: Oct 3 16:56:34.520 buc: ISDN BR0 **ERROR**: UserIdle: process_bri_ca...
Has anyone an idea how to be able to export the VLAN configuration of a device like you would be able to for the running and startup config?I don't want to use the shadow directory but be able to export it via Archive Management.Thanks,Bas Kokken
Can the ACS process user mappings for users that belong to nested groups?i.e. user Dave belongs to engineering group and this group is contained in the CompanyA groupCan the ACS be setup to map user Dave to a certain ACS group based on the CompanyA g...
Actually I did.When I upgraded the IOS on the router I mistakenly used the AdvanceIP services as we used that on all 871 routers. The 876 should, however have been upgraded with the Enterprise version. The fault message was due to a license issue.Too...
I am not sure if I understand this correctly but you want to build a VPN on a point-to-point FR?Why if I may ask: VPN is to safeguard your traffic. But that is the whole idea of FR.Have you checked your crypto maps, ACLs etc. Clear all VPN config inf...
Has anyone found a solution or a reason for this problem.I have the ame problems as described in this thread and am REALLY in need for some suggestions.Thanks for all suggestions
For the WLSE, the CISCO-DEVICE-EXCEPTION-REPORTING-MIB should be loaded.I am not sure if this will result in a workable decode for the traps sent by the WLSE as it sends it all with the same OID.We are also currently investigating the usability of WL...
Roman,Path analysis: this might be because you have disabled IP redirects.We have the same problem. CM states that the VLAN mapping table is not complete. But there are REALLY LIMITED number of mappings in this table. I found that IP redirects should...