In the pdf for configuring CER for CCM3.3 or 4.X, in the chapter for creating the ELIN route patterns it says. "Use Calling Party's External Phone Number Mask. Select this"Why would you select to use Calling Party's External Phone Number mask when th...
For my inbound gateways I have 4 as the significant digits. For my PSAP call back do I need to change the route point from 913XXXXXXXXXX to 913XXXX or should I leave it as default? And do I need to shorten my ELINS to 4 digits as well?Thanks
We will be installing two new 6513?s with Sup 720?s in our datacenter each residing on a separate floors in the same building. Connecting the switches is an 8 GB Ether Channel.Would it be better to use HSRP or GLBP between switches?ThanksJoe
Sup 720’s in the 6513 go in slot 7&8 and for the 6509 go in slot 5&6. Does the 6509 have dual channel fabric for all slots or only 7,8,9? Where as the 6513 only has dual channel fabric in slots 9-13?THXJoe
My NAS ( EMC NS 500) seems slow when connected to my 6513. Takes 2 minutes to copy a 1 GB file. I have it configued at 1000FD with it running in a two port etherchannel. Do I need to specify a load-balance dst-mac command on the port channel?
Thank you for the quick response.In our case only 4 is being sent to the CER not 10#1 Inbound call from router sends 2229 to call manager.#2 Call manager matches it to a translation pattern of 2229 with a called party transform mask of 2229 and a pre...
Our core datacenter switches were purchased with 6148 GE TX 1MB per 8 ports. We had 96 servers all pushing 1GB. When backups or a heavy network intensive application would cause problems with our VOIP call center. Phones would lose connections to ca...
