Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My client has a pair of 4948's with statics in a Data Centre terminating a number of WAN access circuits via firewalls and now has a requirement to run BGP and route reflectors on the 4948's. There would be a total max throughput of only around 40...
Hi,Have a client whose IOS 6500/sup720 shows the following output:----------show output--------Core_2#sho spanning-tree vlan 1Spanning tree instance(s) for vlan 1 does not exist.--------------------------------------Config Excerpt--------no spanning-...
Jeff,A one time discovery to identify hardware inventory and software that is out of date is exactly the sort of thing we are looking for. Its for a large branch office Wan of around 800 sites of varying sizes. Which of the products you mention would...
OKBut isnt vlan 1 inherent on an 802.1q trunk. eg in the config below vlan 1 is still allowed right ?interface GigabitEthernet1/27 description ##UPLINK-Price_01_+49## switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 101,5...
Hi,Just to clarify:Are you saying that even though vlan 1 is configured on trunk ports that are up, because vlan 1 is not active on any access port that stp for vlan 1 is not active?I expected that because vlan 1 is present (inherently) on 802.1q tru...
Hi Francois,There are some ports active in vlan 1 (see below). Any other ideas why I see stp not enabled for vlan 1 but this does not show in the config ?-----------------------------------Core_1#sho vlan id 1VLAN Name Sta...
Thanks for all the replies. For clarity I should have said that the legacy access switches are non Cisco with dual uplinks from either single access or dual access switches. They support a L2 link failover feature that does not rely on spanning tree....
