Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,After many tries and advices i still can not configure my router properly...So i am uploading the topology, a file with the wired (and operational - Config_1_BVI1.txt) configuration, and a file with the last try...On this topology the wired part w...
I have the following physical sratus... PC -> Wireless Card -> Router 876W (192.168.100.1)-> Sitch -> AccessPoint -> ....wireless..... -> Access Point -> Modem/Router (192.168.0.1) -> ADSL Line On this configuration with the above IPs i have create a...
I have the following physical sratus...PC -> Wireless Card -> Router 876W (192.168.100.1)-> Sitch -> AccessPoint -> ....wireless..... -> Access Point -> Modem/Router (192.168.0.1) -> ADSL LineOn this configuration with the above IPs i have create a V...
How can i achieve this with IOS Commands on a 876W Router...I want to encapsulate dot1q interface to switch port 0!interface fastethernet 0 encapsulation dot1q 1
HI,i have a 876W Router which is connected to the internet throw a wireless connection to another modem/router, through Access Points. On the side of the modem/router there is a LAN With IP 192.168.0.1. I have create a second lan as VLan with IP 192....
Hi GeorgThank you for your reply... as i told you i had no luck so far and i really need someone to help me...You say to me, to try to connect my AP on port FastEthernet 4. You mean FastEthenet 3 (FE3) on the router? I am asking you because my router...
Hi,i am uploading a .doc with the topology of the network, and two config files.The file Config_1_BVI1.txt describes the configuration with witch i am able to surf on the net (and reply to you...).The file Config_2_Dot11Radio.txt describes the config...
Hi GEORG,Unfortunately, nothing. Its like to ignore totaly the BVI2 and the FastEthernet Configuration. Write now i have connect the Access Point (D-Link!!!) on router's port 0 and i can browse using the IP 192.168.100.2... I can see the Access Point...
Hi Georg,As you saw in the config file the following configuration didn't work..interface FastEthernet0 switchport access vlan 2 switchport trunk native vlan 2 no ip address no cdp enableI tried this one too... niether this worked...interface FastEth...
