Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
WAP model 9120AXWLC 9800CLClients are disconnecting randomly from WAP and SSID is dot1x not PSK based this is happening on particular office building other office building works fine. Is there any command in Cisco WLC to find out reason of disconnect...
Hi What does those message explain Can some one explain if there is any issue in config. these messages keep popping up in logs%IPSEC-3-REPLAY_ERROR: F0: cpp_cp_svr: IPSec SA receives anti-replay error, DP Handle 110, src_addr <IP address>, dest_addr...
I have 9300 switch with below module. Module support 8 Combo ports I see 8 Ten Gig Ports but only 4 1 Gig ports. Also i cant use Gi interface I configured Gig 1/1/1 interface as uplink but it brought up Ten1/1/1 interface instead. How i can use C9300...
Hi can anyone tell how to check Cisco 8300 series edge platform router hardware throughput verification command or any table for base license as well as booster.
Nothing it seems by default it uses interface as Ten 1/1/1-8 with backward compatibility to 1 G. Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 157134250 could be because Core side is Ten/1/1/1 and Access side is G1/1/1 ?
it shows the table in bps so i calculate to Mbps which is total; input 13 and output also 14. so again what i understood above is correct or not? "I see so what i finally under stand upstream traffic for example is 30 Mbps upstream and downstream is ...
i see so what i finally under stand upstream traffic for example is 30 Mbps and downstream is 70 at the same time not 50 up and 50 down. Correct me if i am wrong.
