WAP model 9120AXWLC 9800CLClients are disconnecting randomly from WAP and SSID is dot1x not PSK based this is happening on particular office building other office building works fine. Is there any command in Cisco WLC to find out reason of disconnect...

Hi What does those message explain Can some one explain if there is any issue in config. these messages keep popping up in logs%IPSEC-3-REPLAY_ERROR: F0: cpp_cp_svr: IPSec SA receives anti-replay error, DP Handle 110, src_addr <IP address>, dest_addr...

I have 9300 switch with below module. Module support 8 Combo ports I see 8 Ten Gig Ports but only 4 1 Gig ports. Also i cant use Gi interface I configured Gig 1/1/1 interface as uplink but it brought up Ten1/1/1 interface instead. How i can use C9300...

Hi can anyone tell how to check Cisco 8300 series edge platform router hardware throughput verification command or any table for base license as well as booster.

what is the Cisco 881 and 1941 max throughput level. Can confirm below?i saw 881 20Mbps1941 25 Mbps